By | February 6, 2015
This is a DIY project by using this project you can Measure up to 220 cm with an accuracy of 2cm This project is very simple after completing this project you will see the Results on Lcd.
Components :

Circuit Diagram:
Code:
                            Click Here To Download The Code 

Category: Arduino

About Abid Jamal

Abid Jamal Received his B.S. Degree in Electronics & Communication in 2014 (Gold Medalist) from University of Lahore, Islamabad, Pakistan and Master’s Degree in Electrical Engineering from Capital University of science and technology, Islamabad, Pakistan, in 2016. He is the Creator of www.Electronicslovers.com website. Awarded by “A” grade in Electronic & circuits MIT online certificate. He achieved an academic Excellence certificate in the year 2014. He received Dean Honor Roll award for earning GPA 3.67, Spring-2015 in MSEE. He has done many projects using Different kinds of microcontroller. His research interests include Radar Cross Section measurements, Smart Grid communications, Intelligent transportation systems, driver-less car, cellular mobile communication & networks, improve Smartphone’s battery life for 3G+LTE user’s, and embedded systems.

5 Replies to “Using Arduino and Ultrasonic sensor Find The Range and Display reading on LCD”

  1. hypertuch

    Hello Mr. Jamal…this is a great great project..I was asking how to create arduino code, that makes 3 servos move slowly, but randomly, independent from each other?

    Reply
  2. Abid Jamal

    First you need to know how to interface one servo motor with arduino ….But remember ever microcontroller can do one task at a time …. You can do this with the help of micro delay trick

    Reply
  3. Abid Jamal

    First you need to know how to interface one servo motor with arduino ….But remember ever microcontroller can do one task at a time …. You can do this with the help of micro delay trick

    Reply
  4. hypertuch

    Thanks alot. I did some code connecting 3 servos to 9-8 and 10…it does give random position to each one to go to…but when u put them on the robot head..it goes to new angle so fast like a crazy robot…I need head to move random, but slowly like a human…I can share the schematic and code if you want to give me advice.

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *